|
DTC P1125
|
TP sensor intermittent
|
|---|---|
|
DETECTION CONDITION |
• Indicates TP sensor signal was intermittent.
|
|
POSSIBLE CAUSE |
• TP sensor malfunction
• PCM malfunction
|
Diagnostic procedure
|
STEP
|
INSPECTION
|
ACTION
|
|
|---|---|---|---|
|
1
|
VERIFY FREEZE FRAME DATA HAS BEEN RECORDED
• Has FREEZE FRAME DATA been recorded?
|
Yes
|
Go to next step.
|
|
No
|
Record FREEZE FRAME DATA on repair order, then go to next step.
|
||
|
2
|
VERIFY RELATED SERVICE INFORMATION AVAILABILITY
• Check for related Service Information availability.
• Is any related Service Information available?
|
Yes
|
Perform repair or diagnosis according to available Service Information.
• If vehicle is not repaired, go to next step.
|
|
No
|
Go to next step.
|
||
|
3
|
VERIFY OTHER DTC PRESENT
• Is DTC P0122 or P0123 present?
|
Yes
|
Go to applicable DTC inspection.
(See DTC TABLE [YF (2.0L Zetec)].)
|
|
No
|
Go to next step.
|
||
|
4
|
INSPECT TP SENSOR
• Inspect the TP sensor.
• Is there any malfunction?
|
Yes
|
Replace the TP sensor, then go to next step.
|
|
No
|
Go to next step.
|
||
|
5
|
VERIFY TROUBLESHOOTING OF DTC P0122 COMPLETED
• Make sure to reconnect all disconnected connectors.
• Clear DTC from memory using WDS or equivalent.
• Start engine.
• Perform "KOEO/KOER self-test"
• Is same DTC present?
|
Yes
|
Replace PCM, then go to next step.
|
|
No
|
Go to next step.
|
||
|
6
|
VERIFY AFTER REPAIR PROCEDURE
• Perform "After Repair Procedure".
• Is there any DTC present?
|
Yes
|
Go to applicable DTC inspection.
(See DTC TABLE [YF (2.0L Zetec)].)
|
|
No
|
Troubleshooting completed.
|
||