No.3 THE CRUISE CONTROL DOES NOT DISENGAGE WHEN THE BRAKES ARE APPLIED

id0103c8806200

STEP

INSPECTION

ACTION

1
CHECK THE BRAKE LIGHT FOR CORRECT OPERATION
Turn the ignition switch off.
Check the brake light for correct operation by depressing and releasing the brake pedal.
Do the brake lights operate correctly?
Yes
Go to the next step.
No
Refer to Section 09-18.
2
CHECK THE BRAKE CIRCUIT
Disconnect the cruise actuator connector.
Depress the brake pedal.
Measure the voltage between the cruise actuator terminals C and A (harness-side).
Is the voltage 10 V or more?
Yes
Install a new cruise actuator.
Inspect the system for normal operation.
No
Repair or replace the harnesses.
Inspect the system for normal operation.