No.4 THE CRUISE CONTROL DOES NOT DISENGAGE WHEN THE CLUTCH IS APPLIED
id0103c8806300
STEP
INSPECTION
ACTION
1
CHECK THE CLUTCH SWITCH
Turn the ignition switch off.
Disconnect the clutch switch connector.
Depress the clutch pedal.
Measure the resistance between the clutch switch terminals B and C (part-side).
Is the resistance
less than 5 ohms
?
Yes
Go to the next step.
No
Install a new clutch switch.
Inspect the system for normal operation.
2
CHECK CIRCUIT FOR OPEN
Turn the ignition switch off.
Disconnect the cruise actuator connector.
Measure the resistance between the cruise actuator terminal I (harness-side) and the clutch switch terminal C (harness-side).
Is the resistance
less than 5 ohms
?
Yes
Go to the next step.
No
Repair or replace the harnesses.
Inspect the system for normal operation.
3
CHECK CIRCUIT FOR OPEN
Measure the resistance between the clutch switch terminal B (harness-side) and ground.
Is the resistance
less than 5 ohms
?
Yes
Install a new cruise actuator.
Inspect the system for normal operation.
No
Repair or replace the harnesses.
Inspect the system for normal operation.