No.7 FLASH CODE 2 - BRAKE SWITCH CIRCUIT FAILURE

id0103c8806600

STEP

INSPECTION

ACTION

1
CHECK THE BRAKE LIGHT OPERATION
Depress and release the brake pedal while observing the brake light.
Do the brake lights operate correctly?
Yes
Go to the next step.
No
Refer to Section 09-18.
2
CHECK THE BRAKE CIRCUIT
Turn the ignition switch off.
Disconnect the cruise actuator connector.
Disconnect the PCM connector.
Disconnect the ABS HU/CM connector.
Disconnect the brake switch connector.
Measure the resistance between the following terminals:
• Cruise actuator terminal G and PCM terminal 92 (harness-side)
• Cruise actuator terminal G and ABS HU/CM terminal V (harness-side)
• Cruise actuator terminal G and brake switch terminal A (harness-side)
Are the resistances less than 5 ohms?
Yes
Install a new cruise actuator.
Inspect the system for normal operation.
No
Repair or replace the harnesses.
Inspect the system for normal operation.