|
POSSIBLE CAUSE
|
• When the gear position is fixed in 3GR due to the fail-safe operation, malfunction is in the ATX.
• Perform malfunction diagnosis according to No.6 "LOW MAXIMUM SPEED AND POOR ACCELERATION".
-
1. Clutch burnt
-
• Line pressure low
-
• TP sensor malfunction
-
• VSS malfunction
-
• Input/turbine speed sensor malfunction
-
• Sensor GND malfunction
-
• Shift solenoid A, B or C malfunction
-
• Control valve body malfunction
-
2. 3GR is fixed (Operation in fail-safe function)
-
• Short or open circuit in wiring harness
-
• Poor connection of connector
-
• Poor GND of shift solenoid
-
• Malfunction of electronic parts of output and input system
-
Note
-
• Before following the troubleshooting steps, make sure that the Automatic Transaxle On-Board Diagnostic and Automatic Transaxle Basic Inspection are conducted.
|