DTC INSPECTION [IMMOBILIZER SYSTEM (PATS)(L3)]

Security light

1. Turn the ignition switch to the ON position.

2. Verify the security light status.

• If there is any malfunction:

- After any malfunction is detected, the security light will function as follows for approx. 1 min.

• DTC 11-15: Flashes

• DTC 21: Illuminated

• If there is no malfunction:

- The security light illuminates for approx. 3 s and goes out.

3. When any malfunction has been detected, read the DTCs via the flashing patterns displayed after the security light flashes or is illuminated for approx. 1 min.

• Perform troubleshooting according to the corresponding DTC inspection.

Note

• The security light flashes to display the DTC 10 times.

• If multiple DTCs that can be confirmed with the security light are detected, only the DTC with the lowest number of those detected will be displayed by the security light.

WDS or equivalent

1. Connect the WDS or equivalent to the DLC-2.

2. Verify if any DTCs are displayed.

• If any DTCs are displayed, perform troubleshooting according to the corresponding DTC inspection.

3. Disconnect the WDS or equivalent.