No.1 SECURITY LIGHT DOES NOT OPERATE CORRECTLY (YF (2.0L Zetec), AJ (3.0L Duratec))

id0903b38140g0

Possible Cause

• PCM malfunction

• Instrument cluster malfunction

• Communication error between instrument cluster and PCM

Diagnostic Procedure

STEP

INSPECTION

ACTION

1
INSPECT OTHER WARNING LIGHTS AND SECURITY LIGHT CIRCUIT IN INSTRUMENT CLUSTER
• Turn the ignition switch to the ON position.
• Do other warning lights and security light in the instrument cluster illuminate normally?
Yes
Turn the ignition switch to the LOCK position, then go to the next step.
No
Inspect the instrument cluster, then go to the next step.
2
CONNECT WDS OR EQUIVALENT AND PERFORM DTC INSPECTION
• Is DTC U1262 displayed?
Yes
Communication error between instrument cluster and PCM (SCP)
Inspect the wiring harness and connector between the instrument cluster and PCM.
• Malfunction in the wiring harness and connector.
- Repair or replace the wiring harness and connector, then go to the next step.
• Wiring harness and connector are normal.
- Repair or replace the instrument cluster.
No
Go to the next step.
3
Verify that the malfunction does not recur.
• Turn the ignition switch to the ON position.
• Does the security light operate correctly?
Yes
Troubleshooting completed.
No
Replace the PCM. If the malfunction recurs after reverifying the symptom, go to Step 1.