TRANSMITTER ID CODE PROGRAMMING

Note

• All transmitters (15K601) must be programmed at the same time.

• All previous transmitter identification codes (TIC's) will be erased when programming mode is entered.

• To program (or reprogram) the transmitters into the generic electronic module (GEM)(14B204), carry out the following steps.

1. Turn the ignition from OFF to ON eight times within 10 seconds, ending in ON. If the GEM has successfully entered program mode, it will lock and unlock all the doors.

Note

• The first TIC must be entered within 7.5 seconds of entering the program mode and additional TICs must be entered within 7.5 seconds of the first TIC. The programming mode is exited whenever the timing constraints are not met.

2. Press any button on a transmitter, and the doors will lock and then unlock to confirm that each transmitter has been programmed.

3. If the door locks do not respond for any transmitter, wait for several seconds and press the button again.

4. Turn the ignition switch to the OFF position, or wait up to five minutes after step 1, to exit program mode. If a transmitter has been programmed (or reprogrammed), the GEM will lock and unlock all the doors one last time.