Selector Lever

Selector Lever

Selector Lever:

Removal
1. Remove the front floor console.
2. Disconnect the selector lever cable from the selector lever.





3. Disconnect the selector lever cable from the selector lever housing.





4. Disconnect the selector lever housing electrical connector.





5. Disconnect the wiring harness from the selector lever housing.





6. Remove the 4 nuts and remove the selector lever housing from the vehicle.





Installation

NOTE: When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place and the selector lever cable end is snapped onto the ball stud. Press the selector lever cable into the selector lever cable bracket and listen for the selector lever cable to click in place. Pull back on the selector lever cable to make sure that it is locked into the selector lever cable bracket. Also make sure that the selector lever cable end is correctly installed onto the ball stud. Pull back on the selector lever cable end to make sure that the selector lever cable end is correctly installed.

1. Install the selector lever housing.
^ Tighten to 9 Nm (80 lb-inch).





2. Connect the wiring harness to the selector lever housing.





3. Connect the selector lever housing electrical connector.





4. Install the selector lever cable onto the selector lever housing.





5. Connect the selector lever cable onto the selector lever.





6. Install the front floor console.