Garnishes and Moldings
MOLDINGSREMOVAL AND INSTALLATION
Removal Steps 1-7:
REMOVAL SERVICE POINT
[[A]]ROOF DRIP MOULDING REMOVAL
CAUTION: If the moulding has become warped, it should not be reused.
Use special tool window moulding remover (MB990449) to pry out the moulding.
INSTALLATION SERVICE POINTS
]]A[[ DRIP MOULDING CLIP B/DRIP MOULDING CLIP A INSTALLATION
1. The drip moulding clips A and B differ according to where they are used, so check the identification color before installation.
2. After installing the clip to the front pillar outer in alignment with its section A, cut from section B.
]]B[[ FRONT DRIP MOULDING CLIP C/FRONT DRIP MOULDING CLIP B/FRONT DRIP MOULDING CLIP A INSTALLATION
The front drip moulding clips A, B and C differ according to where they are used, so check the identification color before installation.
]]C[[ ROOF DRIP MOULDING INSTALLATION
Install the clips to the roof drip moulding before installing the moulding to the vehicle body.