Garnishes
GARNISHESSIDE SILL GARNISH REMOVAL AND INSTALLATION
Removal Step 1:
Required Special Tool:
- MB990784: Ornament Remover
Removal Steps 1-2:
Required Special Tool:
- MB990784: Ornament Remover
REMOVAL SERVICE POINTS
[[A]] SIDE SILL GARNISH REMOVAL
Gently lift and remove the side sill garnish. If there is any double-sided tape remaining on the side sill garnish, remove according to the following instructions.
[Remove double-sided tape remaining on the body surface]
1. Attach protection tape all the way along the edges of the double-sided tape which is still adhering to the body.
2. Scrape off the double-sided tape with a resin spatula as possible.
3. Peel off the protection tape.
4. Use a shop towel moistened with 3M(TM) AAD Part number 8906 or equivalent to wipe the body.
[Remove double-sided tape remaining on side sill garnish and adhere double-sided tape (when re-using side sill garnish)]
1. Scrape off the double-sided tape on the side sill garnish with a resin spatula as possible.
2. Use a shop towel moistened with 3M(TM) AAD Part number 8906 or equivalent to wipe the side sill garnish surface.
3. Remove only a small portion of the residual adhesive.
4. Adhere the double-sided tape as specified on the side sill garnish. (Refer to double-sided tape adherence location or.)
INSTALLATION SERVICE POINTS
]]A[[ SIDE SILL GARNISH INSTALLATION
1. Tear off the double-sided tape backing paper.
NOTE: If you attach the adhesive tape to the edge of the backing paper, it will be easy to tear off.
2. Install the side sill garnish.
NOTE: If the double-sided tape is difficult to affix in cold temperature, etc., warm the bonding surfaces of the body and side sill garnish to about 40 - 60 °C (104 - 140 °F) before affixing the tape.
3. Firmly press in the side sill garnish.
]]B[[ PROTECT FILM INSTALLATION
1. Installation position
Attach protect film in the position shown in the illustration.
CAUTION:
- The ambient temperature should be 20 °C (68 °F) to 38 °C (100 °F). Ensure that the working area is clean.
- If ambient temperature is less than 20 °C (68 °F), heat the protect film and application surface to a temperature of 20 °C (68 °F) to 30 °C (86 °F).
- Be careful that air bubbles are not formed under the protect film.
2. Installation procedure
1. Use 3M(TM) AAD Part number 8906 or equivalent to degrease the protect film application surface.
2. Remove protection sheet from the protect film, and apply the film to the specified position.
LIFTGATE GARNISH REMOVAL AND INSTALLATION
