Removal and Installation

INTAKE MANIFOLD

REMOVAL AND INSTALLATION [2.4L ENGINE]

Pre-Removal Operation And Post-Installation Operation:

Removal Steps 1-18:

REMOVAL SERVICE POINT

[A] POWER STEERING OIL PUMP ASSEMBLY

REMOVAL
1. With the hose installed, remove the power steering oil pump assembly from the bracket.
2. Tie the removed power steering oil pump assembly with a string at a position where it will not interfere with the removal and installation of the inlet manifold.

INSTALLATION SERVICE POINTS

[A] SCREW INSTALLATION

CAUTION: Do not over-tighten. As the self-forming-type screw is used, the excessive torque can damage the inlet manifold threads.

[B] MANIFOLD ABSOLUTE PRESSURE SENSOR INSTALLATION

CAUTION:
- Install the manifold absolute pressure sensor, taking care not to give a shock to it.
- Do not use a manifold absolute pressure sensor that has fallen down.

[C] INLET MANIFOLD ASSEMBLY/INJECTOR PROTECTOR FRONT INSTALLATION
Install the inlet manifold assembly and the injector protector front, and tighten mounting bolts and nuts temporarily.

NOTE: The tightening of the fuel delivery pipe, the inlet manifold assembly and the injector protector front and rear has the specified order. Temporarily tighten the inlet manifold assembly and injector protector front mounting bolts and nuts (Refer to MFI - Fuel Injector).