Parking Brake Control: Service and Repair

PARKING BRAKE CONTROL





Removal and Installation
REMOVAL
1. Disconnect return spring from equalizer.
2. Remove right and left rear cables from equalizer.
3. Remove front parking brake cable bolts from under vehicle.
4. Remove rear half of center console.
5. Remove four control lever assembly bolts, then remove control lever assembly.
6. Remove the front cable grommet and cover from control lever assembly.
7. Remove front cable to control lever assembly bolt.
8. Remove the control lever assembly adjusting nut, then remove front cable.

CAUTION: Do not reuse adjusting nut after removing it.

9. Remove the rear disc rotors.
10. Remove parking brake shoes, and remove rear cable from toggle lever.
11. Remove right and left rear cable bolts and nuts, then remove right and left rear cables.

INSTALLATION
^ Installation is in the reverse order of removal.

CAUTION:
^ Do not reuse adjusting nut after removal.
^ Install the control lever assembly bolts in a criss-cross pattern.

^ Adjust parking brake.