A/T Does Not Shift: 5th Gear -> 4th Gear

A/T Does Not Shift: 5th gear -> 4th gear

SYMPTOM: When shifted from D5 to D4 position, does not downshift from 5th to 4th gears.

DIAGNOSTIC PROCEDURE
1. CHECK SELF-DIAGNOSIS RESULTS
Perform self-diagnosis. Refer to AT-90, "SELF-DIAGNOSTIC RESULT MODE". Self-Diagnostic Result Mode
Is any malfunction detected by self-diagnostic results?
YES >> Check the malfunctioning system. Refer to AT-90, "SELF-DIAGNOSTIC RESULT MODE". Self-Diagnostic Result Mode
NO >> GO TO 2.

2. CHECK OVERDRIVE CONTROL SWITCH CIRCUIT
Check overdrive control switch. Refer to AT-174, "OVERDRIVE CONTROL SWITCH". Overdrive Control Switch
OK or NG
OK >> GO TO 3.
NG >> Repair or replace damaged parts.

3. CHECK A/T FLUID LEVEL
Check the A/T fluid level.
OK or NG
OK >> GO TO 4.
NG >> Refill ATF.

4. CHECK CONTROL CABLE
Check the control cable.
^ Refer to AT-217, "Checking of A/T Position". Testing and Inspection
OK or NG
OK >> GO TO 5.
NG >> Adjust control cable.

5. CHECK A/T FLUID CONDITION
1. Remove oil pan.
2. Check A/T fluid condition. Refer to AT-54, "Fluid Condition Check". Fluid Condition Check
OK or NG
OK >> GO TO 6.
NG >> GO TO 9.

6. DETECT MALFUNCTIONING ITEM
^ Check the malfunction items. If any items are damaged, repair or replace damaged parts. Refer to AT-65, "Symptom Chart" (Symptom No.14). Symptom Chart
OK or NG
OK >> GO TO 7.
NG >> Repair or replace damaged parts.

7. CHECK SYMPTOM
Check again. Refer to AT-62, "Cruise Test - Part 3". Cruise Test - Part 3
OK or NG
OK >> INSPECTION END
NG >> GO TO 8.

8. PERFORM TCM INSPECTION
1. Perform TCM input/output signals inspection. Refer to AT-87, "TCM Input/Output Signal Reference Values". Pinout Values and Diagnostic Parameters
2. If NG, recheck A/T assembly harness connector terminals for damage or loose connection with harness connector.
OK or NG
OK >> INSPECTION END
NG >> Repair or replace damaged parts.

9. DETECT MALFUNCTIONING ITEM
^ Check the malfunction items. If any items are damaged, repair or replace damaged parts. Refer to AT-65, "Symptom Chart" (Symptom No.14). Symptom Chart
OK or NG
OK >> GO TO 7.
NG >> Repair or replace damaged parts.