| Camshaft Material | Hardened Cast Gray Iron |
| Bearing Number | 5 |
| Bearing Number on Left Cylinder Head Intake | 6 |
| Bearing Journal Diameter | 1.0610-1.0619 Inch (in) |
| Bearing Bore Diameter (In Cylinder Head) | 1.0635-1.0642 in |
| Bearing Clearance | 0.0020-0.0030 Inch (in) |
| Production Limits | 0.0016-0.0035 Inch (in) |
| Service Limits - Maximum | 0.0035 Inch (in) |
| Runout | 0.0020 Inch (in) |
| Out-of-Round | 0.0002 Inch (in) |
| Straightness | 0.0003 in |
| Thrust Width | 0.9051-0.9091 in |
| Timing (@ 0.150 mm Lift), Intake Opens | 5.6 Degrees Before Top Dead Center (deg BTDC) |
| Intake Centerline | 113 Degrees After Bottom Dead Center (deg ABDC) |
| Intake Closes | 236.8 Degrees After Bottom Dead Center (deg ABDC) |
| Exhaust Opens | 222.5 Degrees Before Top Dead Center (deg BTDC) |
| Exhaust Centerline | 107 Degrees Before Top Dead Center (deg BTDC) |
| Exhaust Closes | 13.8 Degrees After Bottom Dead Center (deg ABDC) |
| Camshaft Lift, Intake | 0.2421 Inch (in) |
| Exhaust | 0.2339 Inch (in) |
| Valve Intake | 0.4134 Inch (in) |
| Exhaust | 0.3937 Inch (in) |
| Duration (@ 0.150 mm Lift), Intake | 242 Degrees (deg) |
| Exhaust | 236 Degrees (deg) |
| Valve Overlap (@ 0.150 mm Lift) | 1.98 Degrees (deg) |
| Left Intake Water Pump Drive End, Diameter | 0.6241-0.6261 in |
| Diameter Within Last 19.5 mm (0.7677 in) | 0.6249-0.6253 in |
| Runout | 0.0059 in |
| Primary Drive Type | Endless Chain |
| Adjustment | Hydraulic, Automatic |
| Pitch | 0.315 in |
| Width | Single Row |
| Secondary Drive Type | Endless Chain |
| Adjustment | Hydraulic, Automatic |
| Pitch | 0.315 in |
| Width | Single Row |
| Camshaft Cover Bolt | 89 Inch Pound-Force (in.lb) |
| Camshaft Drive Chain Guide Access Plug | 39 Inch Pound-Force (in.lb) |
| Camshaft Intermediate Drive Shaft Bolt | 89 Inch Pound-Force (in.lb) |
| Camshaft Seal Retainer Bolt | 27 Inch Pound-Force (in.lb) |