Instrument Panel Cluster (IPC) - Trim Plate Bezel Replacement

Trim Plate Bezel Replacement - Instrument Panel (I/P) Cluster (Aztek)

Removal Procedure

1. Remove the knee bolster panel. Refer toKnee Bolster Replacement (Service and Repair) .




2. Remove the screws from the I/P cluster trim plate at the assist handle.
3. Pull out the I/P cluster trim plate in order to release from the retainers.




4. From the back side disconnect the driver information center (DIC) from the I/P cluster trim plate panel.
5. Loosen the steering column bracket and lower the steering column.
6. Remove the I/P cluster trim plate.



Installation Procedure





1. Align the I/P cluster trim plate to the instrument panel retainers.




2. Connect the DIC to the I/P cluster trim plate panel.
3. Install the I/P cluster trim plate.
Press into place until fully seated.

Notice: Refer to Fastener Notice in Cautions and Notices.

4. Install the screws to the I/P cluster trim plate at the assist handle.

Tighten the screws to 2 N.m (18 lb in).

5. Install the knee bolster panel . Refer to Knee Bolster Replacement (Service and Repair) .
6. Tighten the bolts which secure the steering column bracket.

Tighten the bolts to 6 N.m (53 lb in).