Hood Open Assist Rod Stud Replacement

Hood Open Assist Rod Stud Replacement

Removal Procedure

Caution: When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.

Notice: Apply pressure only at the end of the liftgate/hood assist rod that you are removing or attaching. Do NOT apply pressure to the middle of the rod because damage or bending will result.




1. Open the hood.
2. Release the clip retaining the hood assist rod to the lower hood assist rod ball stud.




3. Remove the lower hood assist rod ball stud (1) from the fender (2).




4. Release the clip retaining the hood assist rod to the upper hood assist rod ball stud.




5. Remove the upper hood assist rod ball stud (1) from the hood (2).

Installation Procedure






Notice: Refer to Fastener Notice in Service Precautions.

1. Install the upper hood assist rod ball stud (1) to the hood (2).

Tighten the upper hood assist rod ball stud (2) to 9 N.m (80 lb in).

2. Press the hood assist rod onto the upper hood assist rod ball stud (1).
3. Ensure that the clip is fully seated on the hood assist rod.




4. Install the lower hood assist rod ball stud (1) to the fender (2).

Tighten the lower hood assist rod ball stud (1) to 9 N.m (80 lb in).

5. Press the hood assist rod onto the lower hood assist rod ball stud (1).
6. Ensure that the clip is fully seated on the hood assist rod.
7. Close the hood.