Receiver Replacement - Digital Radio (Sedan)

RECEIVER REPLACEMENT - DIGITAL RADIO (SEDAN)

REMOVAL PROCEDURE




1. Remove the rear compartment trim panel.

IMPORTANT: Do not swap digital radio receivers between vehicles. Swapping digital receivers between vehicles will activate the digital radio Theftlock, "XM Theftlock" will be displayed.




2. Disconnect the electrical connectors from the receiver.
3. Remove the fastener from the receiver and remove the receiver.

INSTALLATION PROCEDURE




1. Install the receiver and secure with the fastener.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the fastener to 3 N.m (26 lb in).




2. Connect the electrical connector to the receiver.
3. Install the rear compartment trim panel.
4. Perform the setup procedure for the digital radio receiver. Refer to Digital Radio Receiver Setup.