Evaporative Emission (EVAP) Hoses/Pipes Replacement - Engine

EVAPORATIVE EMISSION HOSES/PIPES REPLACEMENT - ENGINE

REMOVAL PROCEDURE
1. Remove the generator.




2. Remove the nuts (1) securing the evaporative emission (EVAP) hose/pipe (2) to the strut tower.
3. Disconnect the EVAP purge hose/pipe (2) from the purge solenoid.




4. Disconnect the engine EVAP purge hose/pipe from the chassis EVAP purge hose/pipe.
5. Cap or plug both the engine and chassis EVAP purge hose/pipes to prevent contamination.




6. Remove the EVAP hose/pipe (2) from the retainer (3).
7. Remove the EVAP hose/pipe (2) from the vehicle.

INSTALLATION PROCEDURE




1. Install the EVAP hose/pipe (2) to the vehicle.
2. Install the EVAP hose/pipe (2) to the retainer (3).




3. Remove the caps or plugs from both the engine and chassis EVAP purge hose/pipes.
4. Connect the engine EVAP purge hose/pipe to the chassis EVAP purge hose/pipe.




5. Connect the EVAP purge hose/pipe (2) to the purge solenoid.

6. NOTE: Refer to Fastener Notice.

Install the nuts (1) securing the evaporative emission EVAP hose/pipe (2) to the strut tower.

Tighten the nuts to 10 N.m (89 lb in).

7. Install the generator.