Catalytic Converter and Intermediate Pipe Heat Shields

NOTE: Inspect the shields for cracks, tears, and missing fasteners. All shields must be firmly attached. Shields must be installed whenever removed for exhaust system or body repairs, etc. to prevent vehicle panel and fuel tank damage.

REMOVAL





WARNING: Make sure vehicle is properly supported and squarely positioned prior to lifting. To help avoid personal injury when a vehicle is on a hoist, provide additional support for the vehicle on the opposite end from which components are being removed. Make sure hoist does not contact fuel or brake lines. heavy work gloves and eye protection must be worn when modifying the exhaust heat shield, and when removing and installing the intermediate exhaust pipe isolator. The exhaust heat shield edges are extremely sharp and contact with the edges could cause personal injury.

1. Raise vehicle squarely on a lift. Refer to lift instructions for positioning vehicle.





2. Remove the three intermediate pipe-to-three way catalytic converter fasteners at converter and discard gasket.
3. Remove intermediate pipe isolator fastener and lower exhaust system to the fullest extent.

CAUTION: Use extreme care when grinding off the rivet heads. Always install all the shields to insure against panel and fuel tank damage.





4. Remove heat shield rivets by grinding off the heads with a small grinder or by punching out the center of the rivet with a 3/32 inch punch. Use a 3/16 inch drill to remove the rivet head without damaging retainer hole.

INSTALLATION
1. Position the heat shields in place.





NOTE: Install the circled rivets shown first to align the shield. The shields also overlap and share some common rivets.

2. Install heat shield rivets.
3. Install catalytic converter to intermediate pipe gasket.
4. Install three intermediate pipe to catalytic converter fasteners. Torque to 45 Nm (33 ft. lbs.).
5. Check exhaust system for leaks.