Body Lock Pillar Trim Finish Molding Replacement - Lower (Sedan/Wagon)

Body Lock Pillar Trim Finish Molding Replacement - Lower (Sedan/Wagon)

Removal Procedure





1. Remove the rear seat cushion. Refer to Rear Seat Cushion Replacement (Coupe) (Rear Seat Cushion Replacement (Coupe))Rear Seat Cushion Replacement (Sedan/Wagon) (Rear Seat Cushion Replacement (Sedan/Wagon)) in Seats.
2. Remove the rear seat carpet retainer molding.
3. Lower the rear seat back.
4. Remove the body lock trim finish molding by pulling firmly, starting at the bottom of the molding to disengage the clips.
5. Slide the molding out from under the body lock pillar upper trim finish molding and the weatherstrip.



Installation Procedure





1. Slide the body lock trim finish molding upper tab into the body lock pillar upper trim finish molding.
2. Line up the attaching clips and firmly snap the body lock trim finish molding into place.
Important: The outboard tabs of the body lock pillar trim finish molding must be positioned under the weatherstrip after installation.



3. Install the rear seat carpet retainer molding.
4. Raise the rear seat back assembly.
5. Install the rear seat cushion. Refer to Rear Seat Cushion Replacement (Coupe) (Rear Seat Cushion Replacement (Coupe))Rear Seat Cushion Replacement (Sedan/Wagon) (Rear Seat Cushion Replacement (Sedan/Wagon)) in Seats.