Output Axle Shaft Sleeve and Seal Replacement
Output Axle Shaft Sleeve and Seal ReplacementTools Required
^ J41228 Stub Shaft Sleeve Installer
^ SA9211T 5th Gear Remover
Removal Procedure
1. Remove the transaxle case side cover.
2. Remove the snap ring from the output axle shaft and discard.
3. Remove the output axle shaft sleeve from the output shaft using SA9211T.
Installation Procedure
1. Use J41228 to install new sleeve on output axle shaft. Ensure that collet is located in snap ring groove when installing.
2. Install a new snap ring on output axle shaft.
3. Install the transaxle case side cover.
4. Start engine, warm up transaxle, and check for leaks.
5. Inspect the fluid level.