35. Park Pawl Actuator Bearing Replacement

Park Pawl Actuator Bearing Replacement

- Tools Required
- DT 46424 Adjustable Bearing Remover
- DT 46516 Driver
- EN 46342 Driver Handle
- SA9133TAxle Seal Puller
- SA9133T- 1 Axle Seal Puller Adapter

Removal





1. Using the DT 46424 (2), and SA9133T- 1 (1), remove the park pawl actuator bearing (69) from the transmission housing.
2. Inspect the bearing for wear or damage. Replace as needed

Installation





Using the 24 mm side of DT 46516 (2) and EN 46342 (1), install the 9 mm x 20 mm x 6 mm park pawl actuator bearing (69) until it bottoms out flush in the transmission case housing.