60. Piston, Connecting Rod, and Bearing Installation

Piston, Connecting Rod, and Bearing Installation

^ Tools Required
- J 8037 Ring Compressor
- J 41742 Connecting Rod Guide Pin
- J 45059 Angle Meter or SA9140E Torque Angle Gage





1. Install the upper bearing half to the connecting rod.
2. Install the J 41742 to the connecting rod in order to guide the connecting rod onto the crankshaft journal.





3. Install the piston into the cylinder bore with the arrow or mark (1) on the top of the piston facing the front of the engine.





4. Hold the J 8037 firmly against the engine block. Using a wooden hammer handle, lightly tap the top of the piston until all of the piston rings enter the cylinder bore.





5. Notice: Refer to Fastener Notice in Service Precautions.

Install the lower bearing half (117), cap (116) and bolts (115).
1 Tighten the bolts a first pass to 20 Nm (14 ft. lbs.).
2 Tighten the bolts a final pass an additional 90 degrees using the J 45059 or SA9140E.





6. Measure the connecting rod end-play. Insert a feeler gage between the connecting rod and crankshaft.
^ Connecting rod end play - new: 0.15 - 0.35 mm (0.006 - 0.014 inch)
^ Connecting rod end play - service limit: 0.45 mm (0.018 inch)
7. If the connecting rod end-play is not within the service limit, install a new connecting rod and measure again. If it is still not within the service limit, replace the crankshaft.