Output Axle Shaft Sleeve and Seal Replacement

Output Axle Shaft Sleeve and Seal Replacement

^ Tools Required
- J 41227 Output Shaft Sleeve Remover
- J 41228 Output Shaft Sleeve Installer
- J 41102 Axle Seal Installer

Removal Procedure
1. Raise and support the vehicle.
2. Remove the left drive axle assembly. Refer to Wheel Drive Shaft Replacement - Front.





3. Remove the output axle seal using a medium screwdriver and a mallet.





4. Remove the drive axle retaining ring from the output axle shaft. Discard the retaining ring.





5. Use the J 41227 to remove the sleeve from the output axle shaft.

Installation Procedure

Important: The output axle shaft sleeve and seal must be replaced together. DO NOT replace the sleeve or seal separately.





1. Use the J 41228 to install a new sleeve on the output axle shaft. Ensure that the collet is located in the retaining ring groove when installing.





2. Install the new output axle seal using the J 41102 and a mallet





3. Install a NEW retaining ring on the output shaft.
4. Install the left drive axle assembly. Refer to Wheel Drive Shaft Replacement - Front.
5. Lower the vehicle.
6. Inspect the output axle shaft sleeve for leaks.
7. Inspect the transmission oil level. Refer to Transmission Fluid Checking Procedure.