Installation
INSTALLATION1) Aligning with the mounting hole of the rear brake back plate, temporarily tighten the rear hub unit bearing to the rear housing.
CAUTION:
^ Be careful not to damage the magnetic encoder.
^ Do not get closer the tool which charged magnetism to magnetic encoder.
2) Tighten the four bolts of the rear housing.
Tightening torque:
65 Nm (6.63 kgf-m, 47.9 ft-lb)
3) Tighten the new axle nut temporarily.
4) Install the rear disc rotor.
5) Install the disc brake caliper on the rear housing.
Tightening torque:
17-inch type
65 Nm (6.63 kgf-m, 47.9 ft-lb)
15-inch type
66 Nm (6.73 kgf-m, 48.7 ft-lb)
6) While pressing the brake pedal, tighten the new axle nuts to the specified torque.
Tightening torque:
190 Nm (19.4 kgf-m, 140.1 ft-lb)
CAUTION:
Do not apply weight to the rear axle before tightening the axle nut. Doing so may damage the hub bearing.
7) After tightening the axle nut, lock it securely.
8) Install the rear wheels.
Tightening torque:
100 Nm (10.20 kgf-m, 73.8 ft-lb)