Installation
INSTALLATION1) Place the disc cover between housing (A) and front hub unit, and tighten the four bolts.
Tightening torque:
65 Nm (6.63 kgf-m, 47.9 ft-lb)
2) Install the front drive shaft.
3) Tighten the axle nut temporarily.
4) Install the disc rotor to hub.
5) Install the disc brake caliper on the housing.
Tightening torque:
17-inch type
155 Nm (15.81 kgf-m, 114.3 ft-lb)
16-inch type
80 Nm (8.16 kgf-m, 59 ft-lb)
6) While depressing the brake pedal, tighten a new axle nut to the specified torque and lock it securely.
CAUTION:
Do not apply weight to the front axle before tightening the axle nut. Doing so may damage the hub bearing.
Tightening torque:
220 Nm (22.43 kgf-m, 162.3 ft-lb)
7) After tightening the axle nut, lock it securely.
8) Install the wheel.
Tightening torque:
100 Nm (10.20 kgf-m, 73.8 ft-lb)