Reclining Motor

INSPECT RECLINING MOTOR PTC THERMISTOR OPERATION
a. Connect the positive (+) lead from the battery to terminal 2, the positive (+) lead from the ammeter to terminal 1 and the negative (-) lead to the battery negative (-) terminal, then recline the seat back to the most forward position.
b. Continue to apply voltage, check that the current change to less than 1 ampere within 4 to 90 seconds.




c. Disconnect the leads from the terminals.
d. Approximately 60 seconds later, connect the positive (+) lead from the battery to terminal 1 and the negative (-) lead to terminal 2, check that the seat back starts to fall backward.
If operation is not as specified, replace the seat adjuster.