Removal and Replacement

Slide Door System - Part 1:

Slide Door System - Part 2:

REPLACEMENT




1. REPLACE SLIDE DOOR HALF OPEN STOPPER SUB-ASSEMBLY
a. Using a screwdriver, remove the 2 clips and cover.

HINT: Tape the screwdriver tip before use.




b. Remove the 2 bolts and disconnect the control cable from the open striker.




c. Disconnect the control cable from the half open stopper.
d. Remove the 2 bolts and half open stopper.




e. Install the half open stopper with the 2 bolts.

Torque: 7.0 Nm (71 kgf.cm, 62 in.lbf)

f. Connect the control cable to the half open stopper.




g. Connect the control cable to the open striker with the 2 nuts.

Torque: 7.0 Nm (71 kgf.cm, 62 in.lbf)







2. REPLACE SLIDE DOOR HALF OPEN STOPPER CONTROL ASSEMBLY
a. Using a screwdriver, remove the rear door scuff plate.
b. Using a screwdriver, remove the back door scuff plate.
c. Using a screwdriver, remove the quarter trim panel.
d. Remove the 2 nuts and half open stopper control.
e. Remove the control cable.
f. Install the control cable, as shown in the illustration.
Dimension (A):3.9 ± 1.5 mm (0.154 ± 0.059 in.)




g. Install the half open stopper control with the 2 nuts.

Torque: 7.0 Nm (71 kgf.cm, 62 in.lbf)




3. REPLACE SLIDE DOOR OPEN STRIKER LH
a. Remove the 2 nuts and open striker.




b. Install the open striker with the 2 nuts.

Torque: 7.0 Nm (71 kgf.cm, 62 in.lbf)

4. REPLACE SLIDE DOOR OPEN STRIKER RH

HINT: Use the same procedures for the LH side.




5. REPLACE SLIDE DOOR OPEN STOP LH
a. Remove the 2 nuts and open stop.




b. Install the open stop with the 2 nuts.

Torque: 7.0 Nm (71 kgf.cm, 62 in.lbf)

6. REPLACE SLIDE DOOR OPEN STOP RH

HINT: Use the same procedures for the LH side.