Installation

2UZ-FE LUBRICATION: OIL PRESSURE SWITCH: INSTALLATION

INSTALLATION

1. INSTALL OIL PRESSURE SENDER GAUGE ASSEMBLY





(a) Apply adhesive to 2 or 3 threads of the sender gauge.
Adhesive:
Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
NOTE: Do not let adhesive adhere to the oil hole.





(b) Install the sender gauge.
Torque: 15 Nm (153 kgf-cm, 11 ft-lbf)
NOTE: Do not start the engine within 1 hour of installation.

(c) Connect the sender gauge connector.
2. INSPECT FOR OIL LEAK Replacement
3. CHECK ENGINE OIL LEVEL Testing and Inspection
4. INSTALL NO. 1 ENGINE UNDER COVER Replacement
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: Some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.