Rear Power Window RH Does Not Operate With Rear Power Window Switch RH

WINDSHIELD / WINDOWGLASS: POWER WINDOW CONTROL SYSTEM: Rear Power Window RH does not Operate with Rear Power Window Switch RH

Rear Power Window RH does not Operate with Rear Power Window Switch RH

DESCRIPTION
HINT: for Double Cab, CrewMax
- If the rear RH side manual UP/DOWN function does not operate, there may be a malfunction in the rear power window regulator switch RH, rear power window regulator motor RH, power window regulator master switch or Harness and connector.

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. CHECK HARNESS AND CONNECTOR (REAR SWITCH RH - BATTERY)




(a) Disconnect the O5 switch connector.
(b) Measure the voltage according to the value(s) in the table below.
Standard voltage:






NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
2. INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY RH




(a) Remove the switch Removal.
(b) Measure the resistance according to the value(s) in the table below.
Standard resistance:






NG -- REPLACE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY RH
OK -- Continue to next step.
3. CHECK HARNESS AND CONNECTOR (REAR SWITCH RH - REAR MOTOR RH)




(a) Disconnect the O5 switch connector.
(b) Disconnect the O3 motor connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard resistance:

for Double Cab:





for CrewMax:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
4. INSPECT REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY RH




(a) Remove the motor Removal.
(b) Apply battery voltage to connector terminals 1 and 2.
(c) Check that the motor gear rotates smoothly as follows.
OK:

for Double Cab:





for CrewMax:





NG -- REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY RH
OK -- Continue to next step.
5. CHECK HARNESS AND CONNECTOR (MASTER SWITCH - REAR SWITCH RH)




(a) Disconnect the N2 master switch connector.
(b) Disconnect the O5 switch connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard resistance:






NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
6. CHECK POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY




(a) Remove the master switch Removal.
(b) Reconnect the master switch connector.
(c) Measure the voltage according to the value(s) in the table below.
Standard voltage:






NG -- REPLACE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY
OK -- GO TO POWER WINDOWS DO NOT OPERATE AT ALL