Reassembly
U151E AUTOMATIC TRANSAXLE: UNDERDRIVE PLANETARY GEAR: REASSEMBLY
1. INSTALL UNDERDRIVE PLANETARY RING GEAR
(a) Install a new snap ring to the outer race of a new radial ball bearing rear.
HINT
When replacing the bearing, replace the counter driven gear with a new one.
(b) Using a piston ring compressor, squeeze the snap ring.
(c) Using SST and a press, press in the outer race of the radial ball bearing rear.
SST : 09950-60020
09951-00890
SST : 09950-70010
09951-07100
NOTICE:
Be sure not to damage the snap ring while installing the outer race.
(d) Install the underdrive planetary ring gear to the counter driven gear.
(e) Using snap ring pliers, install the snap ring.
2. INSTALL UNDERDRIVE PLANETARY GEAR ASSEMBLY
(a) Using SST and a press, press the radial ball bearing rear in the underdrive planetary gear.
SST : 09502-12010
SST : 09950-60010
09951-00260
SST : 09950-70010
09951-07100
NOTICE:
Press the bearing until it becomes flat at the bottom.
(b) Install the counter driven gear with planetary ring gear to the underdrive planetary gear.
(c) Using SST and a press, press in a new radial ball bearing front.
SST : 09502-12010
SST : 09950-60010
09951-00260
SST : 09950-70010
09951-07100
NOTICE:
Press the counter driven gear while rotating it.
(d) Using SST and a press, press in the parking lock gear.
SST : 09502-12010
SST : 09950-60010
09951-00260
SST : 09950-70010
09951-07100
NOTICE:
Press the counter driven gear while rotating it.
3. INSTALL DIFFERENTIAL DRIVE PINION
(a) Using SST and a press, press the differential drive pinion.
SST : 09726-40010
SST : 09950-60010
09951-00260
SST : 09950-70010
09951-07100
NOTICE:
* Press the counter driven gear while rotating it.
* Check the number and position of the gear teeth.
NOTICE:
Press the counter driven gear while rotating it.
4. INSTALL CYLINDRICAL ROLLER BEARING RACE INNER
(a) Using SST and a press, press the cylindrical roller bearing race inner.
SST : 09506-35010
SST : 09950-60010
09951-00260
SST : 09950-70010
09951-07100
NOTICE:
Press the counter driven gear while rotating it.
5. INSTALL FRONT PLANETARY GEAR NUT
(a) Place the underdrive planetary gear in a soft jaw vise.
NOTICE:
Be careful not to damage the differential drive pinion.
(b) Using a socket wrench, install a new lock nut.
Torque : 280 Nm (2855 kgf-cm, 207 ft-lbf)
HINT
Use a torque wrench with a fulcrum length of 750 mm (29.53 in.).
(c) Using a pin punch and hammer, stake the lock nut.
CAUTION:
Be sure that there are no cracks on the nut.
6. INSPECT UNDERDRIVE PLANETARY GEAR PRELOAD Underdrive Planetary Gear