Power Assist System (Brush)

POWER ASSIST SYSTEMS: POWER STEERING SYSTEM (for Brush Type Motor): C1551: IG Power Supply Voltage Malfunction
C1551 - IG Power Supply Voltage Malfunction

DESCRIPTION

The power steering ECU distinguishes the power switch status as on (IG) or off through the IG power source circuit.

WIRING DIAGRAM

INSPECTION PROCEDURE

NOTICE:
If the power steering ECU has been replaced with a new one, perform the assist map writing and the torque sensor zero point calibration Power Steering System (For Brush Type Motor).

HINT
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE

1. READ VALUE USING TECHSTREAM (IG POWER SUPPLY)

(a) Turn the power switch off.

(b) Connect the Techstream to the DLC3.

(c) Turn the power switch on (IG).

(d) Turn the Techstream on.

(e) Enter the following menus: Chassis / EMPS / Data List.

(f) Select the item "IG power supply" in the Data List and read the value displayed on the Techstream.

EMPS

OK:

The normal condition value is displayed on the Techstream.

NG -- CHECK HARNESS AND CONNECTOR (POWER STEERING ECU - BODY GROUND)

OK -- CHECK INTERMITTENT PROBLEMS

2. CHECK HARNESS AND CONNECTOR (POWER STEERING ECU - BODY GROUND)

(a) Disconnect the connectors from the power steering ECU.

(b) Measure the voltage according to the value(s) in the table below.

Standard Voltage:

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- REPLACE POWER STEERING ECU Removal