Installation

LIGHTING (EXT): HIGH MOUNTED STOP LIGHT ASSEMBLY: INSTALLATION

1. INSTALL CENTER STOP LIGHT SET

(a) Secure the wire running through the rear spoiler assembly to the center stop light set wire harness.

(b) Place a cloth on the rear spoiler assembly as shown in the illustration.









(c) Using a clip remover wrapped with protective tape, widen the space inside the rear spoiler assembly, and pull the wire to pass the center stop light set wire harness through the spoiler.

NOTICE:
* Do not apply excess force to the rear spoiler assembly or it may be damaged.
* Do not damage the gasket of the rear spoiler assembly.
* Do not apply excess force when pulling the wire harness or it may break.
(d) Install the center stop light set with the 2 screws to the rear spoiler assembly.









Torque : 1.2 Nm (12 kgf-cm, 11 in-lbf)

(e) Remove the wire from the old center stop light set wire harness.

2. INSTALL REAR SPOILER ASSEMBLY Installation

3. INSTALL BACK DOOR TRIM BOARD Reassembly

4. INSTALL BACK DOOR TRIM BOARD ASSEMBLY Reassembly

5. INSTALL BACK DOOR SIDE GARNISH LH Reassembly

6. INSTALL BACK DOOR SIDE GARNISH RH Reassembly

7. INSTALL UPPER BACK DOOR TRIM PANEL ASSEMBLY Reassembly