B1585

NAVIGATION / MULTI INFO DISPLAY: NAVIGATION SYSTEM: B1585: USB Media Malfunction
B1585 - USB Media Malfunction

DESCRIPTION

This DTC is stored when a malfunction occurs in a connected device.





INSPECTION PROCEDURE

PROCEDURE

1. REPLACE USB DEVICE OR "iPod"

(a) Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.

(b) Turn the power switch off.

HINT
When one of these DTCs has been stored, it is necessary to turn off the power switch to make it possible for the vehicle to recognize a new device when it is connected.

(c) Turn the power switch on (ACC).

(d) Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.

HINT
* If the malfunction occurred when a USB device was in use, use another USB device for the inspection. If the malfunction occurred when an "iPod" was in use, use another "iPod" for the inspection.
* Refer to System Description for compatible formats and versions Description and Operation.

NEXT -- Continue to next step.

2. CLEAR DTC

(a) Clear the DTCs Reading and Clearing Diagnostic Trouble Codes.

NEXT -- Continue to next step.

3. RECHECK DTC

(a) Recheck for DTCs and check if the same DTC is output again.

HINT
If DTCs are detected frequently, replace the multi-media interface ECU.

OK:

No DTCs are output.

NG -- REPLACE MULTI-MEDIA INTERFACE ECU Removal

OK -- USB DEVICE FORMAT WAS INCOMPATIBLE, "iPod" VERSION WAS INCOMPATIBLE, OR USB
DEVICE OR "iPod" WAS DEFECTIVE