Reassembly

SLIDING ROOF / CONVERTIBLE: SLIDING ROOF HOUSING: REASSEMBLY

1. INSTALL ROOF WIND DEFLECTOR PANEL SUB-ASSEMBLY

(a) Engage the 2 guides in the direction indicated by the arrow (1) in the illustration to install the roof wind deflector panel sub-assembly.

Text in Illustration

(b) Engage the 2 springs in the direction indicated by the arrow (2) in the illustration.

NOTICE:
Make sure that the springs are securely installed.

2. INSTALL SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY

(a) Hold down the roof wind deflector panel sub-assembly.

(b) Using a screwdriver, slide the sliding roof drive cable sub-assembly in the direction indicated by the arrow in the illustration to install it.

Text in Illustration

HINT
* Tape the screwdriver tip before use.
* Use the same procedure for the other sliding roof drive cable sub-assembly.

3. INSTALL REAR SLIDING ROOF PANEL

(a) Insert the rear sliding roof panel in the direction indicated by the arrow (1) in the illustration.

(b) Engage the 2 claws in the direction indicated by the arrow (2) in the illustration to install the rear sliding roof panel.

4. ADJUST FULLY CLOSED POSITION

(a) Using a screwdriver, slide the sliding roof drive cable sub-assembly in either direction indicated by the arrows in the illustration and alignment marks.

Text in Illustration

HINT
Tape the screwdriver tip before use.

5. INSTALL SUNSHADE TRIM SUB-ASSEMBLY

(a) Insert the sunshade trim sub-assembly into the sliding roof housing sub-assembly.

(b) Install the sliding roof piece sub-assembly LH with the screw.

Torque : 2.0 Nm (20 kgf-cm, 18 in-lbf)

HINT
Use the same procedure for the RH side.

6. INSTALL SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY

(a) Install the sliding roof drive gear sub-assembly with the 2 bolts.

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

(b) Engage the guide and pin.

Text in Illustration