Installation

LIGHTING (EXT): REAR COMBINATION LIGHT ASSEMBLY: INSTALLATION

HINT
* Use the same procedure for the RH and LH sides.
* The procedure described below is for the LH side.

1. INSTALL REAR COMBINATION LIGHT ASSEMBLY

(a) Engage the guide and pin, and install the rear combination light assembly as shown in the illustration.





Text in Illustration





CAUTION:
When installing the rear combination light assembly, check that the wire harness is not caught between the rear combination light assembly and the body. Failure to do so may cause a short circuit.

(b) Install the 3 nuts.

Torque : 5.9 Nm (60 kgf-cm, 52 in-lbf)

(c) Connect the connector.

2. INSTALL DECK TRIM SIDE PANEL ASSEMBLY Installation

3. CONNECT REAR SEAT OUTER BELT ASSEMBLY Installation

4. INSTALL NO. 2 ROOM LIGHT ASSEMBLY (for LH Side) Installation

5. INSTALL REAR DECK TRIM COVER (for RH Side) Installation

6. INSTALL FRONT DECK SIDE TRIM COVER Installation

7. INSTALL LUGGAGE HOLD BELT STRIKER ASSEMBLY Installation

8. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP

for LH Side: Installation

for RH Side: Installation

9. INSTALL REAR DOOR SCUFF PLATE Installation

10. INSTALL BACK DOOR SCUFF PLATE Installation

11. INSTALL REAR NO. 1 FLOOR BOARD Installation

12. INSTALL FRONT DECK FLOOR BOX Installation

13. INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover) Installation

14. INSTALL DECK FLOOR BOX RH (for RH Side) Installation

15. INSTALL REAR DECK FLOOR BOX Installation

16. INSTALL NO. 1 DECK BOARD Installation

17. INSTALL NO. 2 DECK BOARD Installation

18. INSTALL DECK BOARD ASSEMBLY Installation