Ball Joint

FRONT LOWER BALL JOINT ASSEMBLY LH

Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and take the torque reading on the fifth turn.

Standard turning torque: 0.98 to 3.43 N*m (10 to 35 kgf*cm, 9 to 30 in.*lbf) or less.


REAR NO. 1 SUSPENSION ARM ASSEMBLY LH

Using a torque wrench, turn the nut continuously at a rate of 2 to 4 seconds per turn and take the torque reading on the fifth turn.

Standard turning torque: 3.4 N*m (35 kgf*cm, 30 in.*lbf)