Installation

SUSPENSION: FRONT UPPER SUSPENSION ARM (for 4WD and Pre-Runner): INSTALLATION

1. TEMPORARILY TIGHTEN FRONT SUSPENSION UPPER ARM





(a) Install the front suspension upper arm, and temporarily tighten the bolt, 2 washers and nut.

(b) Install the bracket with the bolt.





Torque : 5.8 Nm (59 kgf-cm, 51 in-lbf)

(c) Install a new nut and a new clip.





Torque : 110 Nm (1,122 kgf-cm, 81 ft-lbf)

2. INSTALL SKID CONTROL SENSOR WIRE





(a) Install the skid control sensor wire with the 2 bolts.

Torque : 12.5 Nm (127 kgf-cm, 9 ft-lbf)

3. INSTALL FRONT WHEEL

Torque : 113 Nm (1,152 kgf-cm, 83 ft-lbf)

4. STABILIZE SUSPENSION

(a) Jack down the vehicle.

(b) Bounce the vehicle up and down several times to stabilize the suspension.

5. FULLY TIGHTEN FRONT SUSPENSION UPPER ARM





(a) Fully tighten the nut.

Torque : 115 Nm (1,173 kgf-cm, 85 ft-lbf)

6. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

Service and Repair