Driver or Passenger Seat Lumbar Control Switch Replacement

Driver or Passenger Seat Lumbar Control Switch Replacement

Removal Procedure

Warning:
Refer to Battery Disconnect Warning Battery Disconnect Warning.


1. Disconnect the battery ground cable from the battery. Refer to Battery Negative Cable Disconnection and Connection (Primary) Battery Negative Cable Disconnection and Connection (Primary)Battery Negative Cable Disconnection and Connection (Auxiliary) Battery Negative Cable Disconnection and Connection (Auxiliary).

Warning:
Refer to SIR Warning SIR Warning.


2. Disable the SIR system. Refer to SIR Disabling and Enabling Service and Repair.

3. Remove the front seat. Refer to Front Seat Replacement - Bucket Front Seat Replacement - Bucket.

4. Remove the outer trim panel. Refer to Seat Cushion Outer Trim Panel Replacement Seat Cushion Outer Trim Panel Replacement.





5. Disconnect the electrical connectors (1).

6. Remove the lumbar support switch, by releasing the retaining tab as shown.

Installation Procedure





1. Install the lumbar support switch.

2. Connect the electrical connectors.

3. Install the outer trim panel. Refer to Seat Cushion Outer Trim Panel Replacement Seat Cushion Outer Trim Panel Replacement.