Removal

REMOVAL






NOTE:
To provide removal clearance between muffler/resonator pipe and rear axle parts, the rear suspension must be relieved of all body weight.

NOTE:
When replacement is required on any component of the exhaust system, it is important that original equipment parts (or equivalent) be used.

1. Raise and support vehicle.

2. Apply a penetrating oil to clamp nuts of component requiring removal.

3. Loosen the band clamp (3) at the muffler to converter pipe connection.

4. Separate muffler pipe from converter pipe.

CAUTION:
Do not use any tools to remove the rubber isolators, remove by hand only. Soapy water or silicone based lubricant spray may be used to assist removal/installation of isolators. DO NOT use a petroleum based lubricant on the isolators, as damage to the rubber material can occur.

5. Remove support isolators from muffler/resonator (4) assembly supports.

6. Remove muffler/resonator assembly by moving assembly forward and guiding the resonator through the rear axle- to- body opening.

7. Clean ends of pipes or muffler to assure mating of all parts. Discard broken or worn insulators, rusted clamps, supports and attaching parts.