Rear

REAR





1. Disconnect and isolate the battery negative cable.
2. From the outside of the liftgate glass (4), remove the rear wiper arm (2) from the rear wiper motor output shaft (5). Wiper Arm - Removal





3. From the inside of the liftgate, remove the trim from the liftgate inner panel (1). Liftgate Trim Panel - Removal.
4. Disconnect the liftgate wire harness connector (4) from the rear wiper motor (2) connector receptacle.
5. Remove the three screws (3) that secure the motor mounting bracket to the liftgate inner panel.
6. Carefully slide the rear wiper motor output shaft and housing out of the bezel and grommet installed in the clearance hole of the liftgate glass.
7. From the outside of the liftgate, remove the output shaft bezel and grommet from the clearance hole in the liftgate glass and discard.