Pinpoint Test G: Easy Exit/Easy Entry Is Inoperative/Does Not Operate Correctly
Seats
Special Tools:
Pinpoint Tests
Pinpoint Test G: Easy Exit/Easy Entry is Inoperative/Does Not Operate Correctly
Normal Operation
The Driver Seat Module (DSM) receives a key out command over the Medium Speed Controller Area Network (MS-CAN) communication network and moves the driver seat rearward about 51 mm (2 in).
This pinpoint test is intended to diagnose the following:
- Easy entry/exit feature is not enabled
- Missing status information - MS-CAN communication bus messages:
- key-in-ignition warning switch status
- gear selector position
- Wiring, terminals or connectors
- Key-in-ignition warning switch
- DSM
PINPOINT TEST G: EASY EXIT/EASY ENTRY IS INOPERATIVE/DOES NOT OPERATE CORRECTLY
NOTE: Verify good battery condition before diagnosing the memory seat system. Poor battery condition may interfere with memory seat operation, even if vehicle starting is possible.
NOTE: If a new DSM has been installed, all seat and power steering column (if equipped) soft stops must be reset. If a new seat track, recline motor or power steering column has been installed, only reset the soft stops for that component being installed new. To reset the soft stops, refer to principles of operation.
NOTE: The transmission gear selector must be in PARK for the easy entry/exit feature to function.
NOTE: Make sure all memory seat DTC and symptom based faults are corrected before proceeding with easy entry/exit diagnosis. Verify the PID(s) states agree with the ignition and transmission gear selector in all positions before proceeding with easy entry/exit diagnosis.
