Brake Disc

Brake Disc

Removal and Installation

1. Remove the wheel and tire. For additional information, refer to Wheels and Tires Removal and Replacement.

2. NOTICE: Do not allow the brake caliper and anchor plate assembly to hang by the flexible brake hose or damage to the hose may occur.

Remove the brake caliper anchor plate bolts and position the anchor plate and caliper assembly aside.

- Support the caliper and anchor plate assembly with mechanic's wire.

- Inspect the brake caliper anchor plate bolt threads for damage and foreign material. Install cleaned and dried anchor plate bolts or install new as necessary.

- To install, tighten to 190 Nm (140 lb-ft).

3. NOTE: If the brake disc binds on the parking brake shoe, remove the adjustment hole access plug and contract the parking brake shoe.

Remove the brake disc.

4. Inspect the brake disc and resurface or install a new brake disc as necessary. For additional information, refer to General Procedures in Brake System - General Information Brake System Inspection.

5. To install, reverse the removal procedure.