Compressor/Pump: Service and Repair

Air Suspension Compressor









Removal and Installation

WARNING: Vent all air pressure from the air suspension system prior to disconnecting or removing any air suspension components. It is dangerous to remove air suspension components while under pressure. Failure to follow this instruction may result in serious personal injury.

1. Remove the inner fender splash shield. For additional information, refer to Front End Body Panels Fender Splash Shield.

2. Disconnect the air line from the compressor drier.
- Compress the quick connect lock ring inward, then pull the line outward from the air drier.

3. Disconnect the air compressor air intake hose.

4. Disconnect the air compressor electrical connector.

5. Remove the 3 air compressor bracket bolts and remove the air compressor and bracket assembly.
- To install, tighten to 15 Nm (133 lb-in).

6. NOTE: When installing the air lines, make sure the white inner air line is fully inserted into the fitting for correct installation.

NOTE: Make sure that there are no objects trapped under or on the bracket.

Make sure that the air compressor is not in contact with any surrounding components that could cause vibration noises.

NOTE: Make sure that the air compressor moves freely in the rubber isolators.

Make sure that the bracket has no deformations that could cause the 3 rubber isolators to load against each other.

To install, reverse the removal procedure.