Selector Lever - Column Shift

Selector Lever - Column Shift









Removal and Installation

1. Apply the park brake.

2. NOTICE: To prevent damage to the selector lever boot, do not pull on the top of the boot frame.

Remove the selector lever boot from the steering column shroud by pressing in on the selector lever boot frame.





3. Position the selector lever boot up the selector lever.





4. NOTE: Steering wheel removed for clarity.

Unsnap and remove the upper steering column shroud from the lower shroud.





5. Remove the lower steering column shroud.

1. Remove the screws and the lower steering column shroud.





6. Disconnect the electrical connector and remove the screw that retains the harness clip to the steering column.





7. Remove the selector lever bolt.
- To install, tighten to 18 Nm (159 lb-in).





8. Remove the selector lever.





9. To install, reverse the removal procedure.