Selector Lever Knob

Selector Lever Knob

Expedition









Navigator









Removal

1. NOTE: Expedition selector lever shown, Navigator similar.

Remove the selector lever trim ring, console tray and cup holder insert.





2. Remove the screw and the console upper trim.





3. Remove and discard the RH selector lever knob cover.

1. Start at the bottom front only.

2. Move towards the top front and remove the cover.





4. Remove and discard the LH selector lever knob cover.

1. Start at the bottom front only.

2. Move towards the top front and remove the cover.





5. Remove and discard the RH selector lever knob screw.





6. NOTE: Verify the LH and RH knob body towers are present and not damaged.

Remove and discard the LH selector lever knob screw.





7. Disconnect the tow/haul switch electrical connector and remove the selector lever knob.





Installation

1. Connect the tow/haul switch electrical connector and install the selector lever knob.





2. Install a new LH selector lever knob screw.
- Tighten to 2 Nm (18 lb-in).





3. Install a new RH selector lever knob screw.
- Tighten to 2 Nm (18 lb-in).





4. Install a new LH selector lever knob cover.





5. Install a new RH selector lever knob cover.





6. Install the console upper trim and the screw.





7. Install the selector lever trim ring, console tray and cup holder insert.