Accelerator Pedal - Adjustable

Accelerator Pedal - Adjustable









Removal

1. If possible, adjust the pedals to the full forward (away from driver) position.

2. NOTE: To prevent setting DTCs, make sure the ignition switch is in the OFF position prior to disconnecting the accelerator pedal electrical connector.

Disconnect the Accelerator Pedal Position (APP) sensor electrical connector.

3. Disconnect the accelerator pedal-to-brake pedal cable from the brake pedal.

4. Remove the 3 bolts and the accelerator pedal assembly.

Installation

1. Install the accelerator pedal assembly and the 3 bolts.
- Tighten to 25 Nm (18 lb-ft).

2. Connect the accelerator pedal-to-brake pedal cable to the brake pedal.

3. Connect the APP sensor electrical connector.

4. Carry out the adjustable pedal indexing procedure. For additional information, refer to Hydraulic Brake Actuation Service and Repair.