Component Tests and General Diagnostics

Left Power Sliding Door Control Unit:
1. Remove the left rear side trim panel.

2. Disconnect the 26P connector (A) and 5P connector (B) from the left power sliding door control unit (C).

3. Inspect the all connector and socket terminals to be sure they are all making good contact.
- If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.





- If the terminals look OK, go to step 4.

4. With connectors disconnected from the left sliding door control unit, and the sliding door closed unless otherwise noted, perform these input tests at the connectors.

Part 1 Of 2:

Part 2 Of 2:

- If any test indicates a problem, find and correct the cause, then recheck the system.

5. Reconnect the connectors to the left sliding door control unit and, with the master switch OFF, perform these input tests at the connectors.





- If any test indicates a problem, find and correct the cause, then recheck the system.

Right Power Sliding Door Control Unit:
1. Remove the right rear side trim panel.

2. Disconnect the 26P connector (A) and 5P connector (B) from the control unit (C).

3. Inspect the all connector and socket terminals to be sure they are all making good contact.
- If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.





- If the terminals look OK, go to step 4.

4. With the connectors disconnected from the right sliding door control unit, and the sliding door closed unless otherwise noted, perform these input tests at the connectors.

Part 1 Of 2:

Part 2 Of 2:

- If any test indicates a problem, find and correct the cause, then recheck the system.

5. Reconnect the connectors to the right sliding door control unit and ,with the master switch OFF, perform those input tests at the connectors.





- If any test indicates a problem, find and correct the cause, then recheck the system.