Audio-Navigation Unit Removal/Installation

Audio-Navigation Unit Removal/Installation

NOTE:

- Put on gloves to protect your hands.
- Take care not to scratch the dashboard and related parts.
- Lay a shop towel under the parts when working on them to protect the face panel from scratches or other damage.
- Eject the discs before removing the audio-navigation unit to prevent damaging the CD/DVD player's load mechanism.
- If you are replacing the audio-navigation unit, write down the audio presets (if possible), then enter them into the new audio-navigation unit.
- There are three different audio-navigation unit trim levels:
- With rear entertainment Ultrawide RES type
- With rear entertainment RES type
- Without rear entertainment
If you are substituting a known-good audio-navigation unit (with HDD), you must substitute the same trim level. For example, if the vehicle has rear entertainment Ultrawide RES type, use a known-good audio-navigation unit for vehicles with rear entertainment Ultrawide RES type. If you use the wrong audio-navigation unit, it may cause a diagnosis error.

- If the audio-navigation unit is replaced or disconnected, a Map Matching must be done.
- Make sure you have the 5-digit anti-theft code.

1. Remove these items:

- Center middle panel Dashboard Center Middle Panel Removal/Installation
- Passenger's middle panel Dashboard Passengers Middle Panel Removal/Installation
- Center panel Dashboard Center Panel Removal/Installation
- Center lower console Dashboard Center Lower Console Removal/Installation

2. Remove the bolts (A) and bolts (B), then pull the audio-navigation switch panel (C) out.





3. Disconnect the connectors, and remove the audio-navigation unit (D).

NOTE: There is a lever lock on connector A (E).

4. Remove the bolts (A) and the brackets (B).





5. Remove the screws, then remove the audio- navigation switch panel (C) from the audio-navigation unit (D).

NOTE: If you are replacing the audio-navigation unit, remove the HDD HDD Removal/Installation.

6. Install the audio-navigation unit in the reverse order of removal.

NOTE: Check any official Honda service website for more service information about patches for the navigation system. Apply any prescribed patches to the new audio-navigation unit.

7. Park the vehicle outside, and do the GPS Initialization.

8. Give the new anti-theft code to the customer if the audio-navigation unit is replaced.